Hi
I wonder if anyone has modeled a owa antenna using the existing element taper
an diameters from the Hygain series 105,155,205 antennas
I have several of these I would like to make them into owa design for the
bandwidth by eliminating the mast to element bracket insulating the element
and inserting an appropriate size piece of tubing inplace of the element to
boom bracket an adjust the spacing I do plan to update the booms to 48ft an
3inch od for the 3 higher band antennas Has anyone every considered this
Im not real sure where to look on the net There is not much out there
de WS9V Skip
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|