Two pretty strong statements.
I'm sure the folks at the marine fleet electronics repair shops I've visited
along the coast here in Orygun, who seem to be unaware that they are
'forbidden' to solder RF connections, would be interested in this
information. I also observed the use of crimping RF connections is growing
in some of the larger marine electronics shops, although for some it appears
to still be a relatively new process. In a couple of the smaller shops I
visited, soldering looked to still be the standard.
Don't know about anything about the aircraft electronics repair shop folks,
out of my sphere of knowledge. But, I would suspect that the standards
relative to RF connections in aircraft is more delineated for obvious safety
reasons.
The folks who were involved in the sat system installation at my home used
only crimping tools and methods, so crimping is obviously appears to be the
'standard' in this sector.
The Davis paper was well done IMHO and I thought presented a fair view of
both methods pros and cons.
Before someone thinks I am anti-crimping, I agree crimping is a sound method
done properly (like soldering). Were I doing a lot of RF connections I'd
sure consider investing in the needed tools and new connectors. But I've
only got one or two to deal with now and then and have lots of time and
patience (and connectors). I've also 60 years ham and work experience in
soldering typical UHF connectors, including N's - but admit I don't get it
exactly right from time to time. Probably wouldn't with a crimping tool
either!!
So, Roger and Bill, what are the industry, trade or government documents
that you state require only crimping of RF connections in the aircraft and
marine industry?????
Don W7WLL
-----Original Message-----
From: Bill Turner
Sent: Wednesday, November 19, 2014 11:51 PM
To: Towertalk
Subject: Re: [TowerTalk] Cordless solder irons
------------ ORIGINAL MESSAGE ------------(may be snipped)
On Wed, 19 Nov 2014 22:42:39 -0500, you wrote:
I'd crimp them. A properly done crimp is more reliable in flexing
conditions than solder connections. In aircraft wiring, where there is
a lot of vibration, all connections must be crimped.
73
Roger (K8RI)
REPLY:
Same thing is true for marine wiring. Solder is forbidden, crimped
connections only.
73, Bill W6WRT
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|