I would imagine it is tough to align one bolt by itself. With two you
hold the alignment with a tool, and slip the bolt in the second hole.
Then the other bolt is already more closely aligned.
Bill W2CQ
On 5/8/2014 10:16 AM, Cal Zethmayr wrote:
Thanks to everyone for the responses and the info
BUT ONE KEY UNANSWERED QUESTION?
WHY the two different bolt sizes?
Like our Club President N4CU-Bob Walker, I called Rohn in Peoria and was
transferred to CODY... turns out he is in SALES not engineering.
He said same thing to me,"I don't know why it's just always been that way."
There is a Rohn Grandson of the founder of the company, but he is away from the
factory on a trip.
SO does anyone know the REASON FOR TWO DIFFERENT BOLT SIZES?
And is Rohn the only tower company that does this?
Cal Z
W4GMH
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|