If you just want to identify what type of ferrite you
have, the easiest thing to do is measure the frequency
at which the phase of the impedance is 45 degrees and
then compare this to the frequency where the
epsilon' and epsilon'' curves cross over.
Rick N6RK
On 4/10/2014 1:58 PM, Earl Morse wrote:
I confess, I am spoiled. I have access to a plethora of RF devices such as
network and impedance analyzers so I wouldn't have to make do with making this
measurement with a rigged up setup.
Earl
N8SS
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|