Funny... I just had this very same conversation concerning loaded masts
on folded over towers with Mike, VE3YF.
Rather than using a completely empty rotor plate just above the rotor,
I'm going to bolt a square piece of UV resistant UHMW (Tivar) with a
center hole slightly larger than the outside diameter of my 2" DOM mast,
in the space where a bearing would normally be utilized.
Jon Pearl - W4ABC
On 4/10/2014 7:29 PM, john@kk9a.com wrote:
If your concern is containing the mast for rotator swaps K7LXC has a great
suggesting of just installing a lower rotator plate with no bearing. Towers
are so imprecise, I cannot imagine trying to line up three bearings and not
have it bind.
John KK9A
To: <towertalk@contesting.com>
Subject: Re: [TowerTalk] Thrust Bearing adjustment
From: "Ed Muns" <ed@w0yk.com>
Reply-to: ed@w0yk.com
Date: Thu, 10 Apr 2014 14:35:21 -0700
The second, lower, thrust bearing is VERY handy when you need to remove the
rotator without first removing all the antennas on the mast above the top
thrust bearing.
Ed W0YK
---
This email is free from viruses and malware because avast! Antivirus protection
is active.
http://www.avast.com
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|