Towertalk
[Top] [All Lists]

Re: [TowerTalk] Drill motor

To: richard@karlquist.com, nf4l@comcast.net, towertalk@contesting.com
Subject: Re: [TowerTalk] Drill motor
From: TexasRF@aol.com
Date: Thu, 20 Feb 2014 10:24:52 -0500 (EST)
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
10 seconds on, 30 seconds off?
 
73/K5GW
 
 
 
 
In a message dated 2/20/2014 7:22:41 A.M. Pacific Standard Time,  
richard@karlquist.com writes:

300 RPM  is too fast for the winch, and the winch will
overheat.  If you slow  down the drill, then the little
fans inside do not provide adequate cooling  for the
drill and the drill overheats.  That is the  dilemma.

Rick N6RK

On 2/20/2014 6:55 AM, Mike Reublin NF4L  wrote:
> I ran across the DeWalt DWD460 drill. It draws 11 amps, and has  
continuously variable speeds in 2 ranges( 0 300 and 0 1300 RPM). Seems like  
that 
would get away from the overheating problem in the worm-gear  winches.
>
> Anyone use one?
>
> 73, Mike NF4L
>  _______________________________________________
>
>
>
>  _______________________________________________
> TowerTalk mailing  list
> TowerTalk@contesting.com
>  http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________



_______________________________________________
TowerTalk  mailing  list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>