I know, I probably should not get too hung up about this, but...
Six weeks ago I finished my second tower... 66 feet of guyed Rohn
45. I have a Mosley Pro-67B @ 68 feet and an 80 Meter Inverted V,
with the apex at 64 feet.
Following the completion I went through all of my antennas and
checked the SWR at various places in the bands. I wanted a
"baseline" to make comparisions to should anything go wrong.
About a week ago I made a few spot checks. The only significant
change that I found was on the Pro-67 and ONLY on 40 Meters.
Initial check - 7.0 - 1.6, 7.1 - 1.4, 7.2 - 1.5, 7.3 - 1.5
New check - 7.0 - 1.8, 7.1 - 1.9, 7.2 - 2.2, 7.3 - 2.1
All other bands/freqs are VERY close to what they were initially.
On the Mosley, the 40 Meter driven element is shared with 12 and 17.
The director is shared with 10, 15 and 20. My guess is that a yagi
problem would affect these other bands.
The only addition I have made is to add a 160 Meter Low Dipole for
receive. It is 10 feet high with the feedpoint at the tower.
Is there a chance that it is interacting with the yagi 58 feet above
it? I grounded the feedpoint of the dipole with no change.
I know I should drop the dipole to the ground but it was such a
hassle snaking it through the woods I have held off doing that.
Any advice?
Thanks and 73
Doug - K1ZO
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk