I am using a K7NV prop-pitch rotator for my almost completed tower project.
For the encoder (magnetic pulse counter) that is mounted inside the PP
motor, I am using a 2 pair small wire cable that has an aluminum foil
shield and ground wire. I will be installing a lightning arrestor at the
base of the tower for these two conductors.
My question, should I ground this foil shield or leave it floating at both
ends (PP rotator and rotator control box)? I would think that it should be
grounded, but does it matter? Any consequences if I do or don't?
Ray,
N6VR
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|