Towertalk
[Top] [All Lists]

Re: [TowerTalk] Comtek phasing controller - how to check the supported b

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Comtek phasing controller - how to check the supported band?
From: krishna kanakasapapathi <kkanakas@cisco.com>
Date: Sun, 10 Nov 2013 12:20:01 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Thanks for the bandwidth. I now have my answer.
73s
krish
w4vku

On 11/10/2013 12:49 AM, krishna kanakasapapathi wrote:
Howdie,
 I have a few Comtek vertical phasing controllers here.
They have not been installed yet, but i would like to check them out on the bench prior to deployment.

Is there a way to check the band that each one claims(product label) it is built for.?
 Appreciate any details.
73s
krish
w4vku
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk



_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>