I see Permatex being referred to a lot. Is there a product by Permatex that
is not a gasket sealing goo? Excuse my ignorance.
Patrick AF5CK
-----Original Message-----
From: GARY HUBER
Sent: Tuesday, August 20, 2013 8:32 PM
To: TT TowerTalk
Subject: Re: [TowerTalk] Penetrox/Noalox vs. Anti-seize compound
His reasoning was that enough bare aluminum-to-aluminum surface area
would remain that the use of the Permatex was very unlikely to negatively
effect antenna performance. Anyone have an opinion on this? Should I
re-do
the joints in question while the antenna is still on the ground? Or would
this be a needless exercise at this point?
I've used Blackburn compound for over thirty years. A nasty, sticky graphite
mixture, it keeps new or cleaned aluminum joints like new after years in
service. When I was just getting into the hobby I salvaged an old TH-4 and
on the recommendation of a couple HAMs who had been at it a few years
drilled and Zip screwed each element piece to make the mechanical -
electrical bond.
73 ES DX,
Gary -- AB9M
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|