I used the top plate holes to guy the P40A Rohn 55G tower and it worked out
well. The top plate hole was too small for my guy cable thimble so a
shackle was needed.
To:Tower Talk <TowerTalk@contesting.com>
Subject:[TowerTalk] Rohn 45AG4 guy tabs?
From:Jay Kesterson <k0gu@verinet.com>
Date:Fri, 16 Aug 2013 14:42:57 -0600
List-post:<towertalk@contesting.com">mailto:towertalk@contesting.com>
I see at least one Rohn 45 seller's web site that calls the tabs on the
45AG4 top plate guy tabs. However I don't see any reference to that in the
Rohn documentation. Except for dimensions Rohn doesn't really say a lot
about the 45AG4. But Rohn always shows the guys attached a few feet below
the tower. So are they guy tabs? I was planning on using them on a tower
with a tall mast (the mast is another subject that will get a post here in a
bit). Guy the tower at the top plate and then not far under the rotator.
Anyone have the scoop on this.
73, Jay K0GU
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|