Towertalk
[Top] [All Lists]

Re: [TowerTalk] Rohn 45

To: "les" <lkemble@charter.net>, <towertalk@contesting.com>
Subject: Re: [TowerTalk] Rohn 45
From: "Dan Cisson" <n4gnr@windstream.net>
Date: Wed, 24 Jul 2013 18:05:43 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Two things you can do...look down all three legs of the 2 sections you are trying to mate up.. there may be one leg bent slightly from a drop..This is a common problem...you can bend it back carefully with a short scissor jack....Or you may be able to "adjust" the legs by bending the cross bars,,with a 5 lb hammer,,be careful,,
this will pull the legs in slightly............
but I suspect one of the 2 sections have been dropped...Good Luck  Dan N4GNR
----- Original Message ----- From: "les" <lkemble@charter.net>
To: <towertalk@contesting.com>
Sent: Wednesday, July 24, 2013 3:48 PM
Subject: [TowerTalk] Rohn 45


I am pre assembling a rohn45 tower but one section will not line up, it appears to be about 1/8 of an inch out on one leg. What is the best way to align the tower section?

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>