Jerry,
I don't have the hole pattern, but if you have the bearing,
and need to make a pattern, you can tape a
piece of thin paper to the bearing, then use the
"side" (vs the point) of an ordinary lead pencil
and rub over the hole locations. Practice.
The hole pattern will transfer to the paper. Use something sharp
to *accurately* punch though the paper at the hole centers. Place
the paper pattern face down on whatever you want to drill, align,
tape in place, center punch the metal as marked on the paper,
then drill the holes. Done.
73,
Charlie, N0TT
On Thu, 20 Dec 2012 08:11:44 -0800 Jerry Gardner <jerryw6uv@gmail.com>
writes:
> Anyone have a drawing of the hole pattern needed for the Rohn TB3
> thrust
> bearing they could send me (or point me to)? You'd think this would
> be on
> the Rohn web site, but darned if I can find it.
>
> 73, Jerry
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|