Here is a start...this is the flat plate that the TB3 fits on
http://www.3starinc.com/manuals/ROHN_BPL25G.pdf
http://www.3starinc.com/rohn_25g_45g_55g_heavy_duty_thrust_bearing_r-tb3.html
Mark N1UK
----- Original Message -----
From: "Jerry Gardner" <jerryw6uv@gmail.com>
To: <TowerTalk@contesting.com>
Sent: Thursday, 20 December, 2012 11:11 AM
Subject: [TowerTalk] Rohn TB3 Hole Pattern
Anyone have a drawing of the hole pattern needed for the Rohn TB3 thrust
bearing they could send me (or point me to)? You'd think this would be on
the Rohn web site, but darned if I can find it.
73, Jerry
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|