I'm all set with a schematic, thanks to K1LI. It looks like the
obviously toasted transistor is Q1027 on the PS-Unit.
73,
Barry N1EU
On Sun, Sep 2, 2012 at 4:23 PM, Barry N1EU <n1eu.barry@gmail.com> wrote:
> I inspected the PSU PCB and see what might be a toasted SM transistor.
> Photo (limited by camera's macro capability):
>
> http://tinyurl.com/8cggxs9
>
> But still hamstrung without a legible schematic.
>
> Thanks for any comments/advice,
> Barry N1EU
>
> On Sun, Sep 2, 2012 at 3:39 PM, Barry N1EU <n1eu.barry@gmail.com> wrote:
>> The fuse is fine. There's a faint "burnt" odor inside the controller.
>> Transformer secondary voltages look good.
>>
>> 1. Does anyone have a legible copy of the schematic? Yaesu's PDF
>> version is illegible at the component level.
>>
>> 2. The interconnect diagram clearly shows Q1/D2 connecting to the PSU
>> PCB via J1007. Can someone please point out where the Q1/D2 circuit
>> is shown on the schematic diagram?
>>
>> Thanks & 73,
>> Barry N1EU
>>
>> On Sun, Sep 2, 2012 at 1:18 PM, Barry N1EU <n1eu.barry@gmail.com> wrote:
>>> I'd appreciate any troubleshooting tips for a suddenly non-turning
>>> G-1000DXA rotor. Cable continuity checks good, reading 500 ohms
>>> across the pot and 64 ohms across the motor back at the controller
>>> connector. If I hang a voltmeter across the motor pins (4,5) on the
>>> back of the controller with cable disconnected, I don't see any
>>> voltage generated by the controller when I press the LEFT/RIGHT turn
>>> buttons. Shouldn't I be seeing DC Voltage? If so, do I next check
>>> the fuse on the PS-Unit PCB or ???
>>>
>>> Any advice appreciated.
>>>
>>> Tnx/73,
>>> Barry N1EU
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|