I'd appreciate any troubleshooting tips for a suddenly non-turning
G-1000DXA rotor. Cable continuity checks good, reading 500 ohms
across the pot and 64 ohms across the motor back at the controller
connector. If I hang a voltmeter across the motor pins (4,5) on the
back of the controller with cable disconnected, I don't see any
voltage generated by the controller when I press the LEFT/RIGHT turn
buttons. Shouldn't I be seeing DC Voltage? If so, do I next check
the fuse on the PS-Unit PCB or ???
Any advice appreciated.
Tnx/73,
Barry N1EU
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|