Towertalk
[Top] [All Lists]

Re: [TowerTalk] best way to apply PreLube

To: Tower Talk <towertalk@contesting.com>
Subject: Re: [TowerTalk] best way to apply PreLube
From: Bob K6UJ <k6uj@pacbell.net>
Date: Sun, 17 Jun 2012 13:46:26 -0700
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
OK,  thats probably better than what I was doing.  I had rubber gloves on and 
cupped my hand behind the cable to deflect the spray back on the cable.
Seemed to work but lost a fair amount of PreLube that dripped down.  


Bob
K6UJ




On Jun 17, 2012, at 1:22 PM, Guy Molinari wrote:

> 
> I held a rag behind the cable when spraying.
> 
>> From: k6uj@pacbell.net
>> Date: Sun, 17 Jun 2012 13:15:40 -0700
>> To: towertalk@contesting.com
>> Subject: [TowerTalk] best way to apply PreLube
>> 
>> 
>> I would like to know from others in the Tower Talk group how they apply 
>> Prelube to their crank up tower cables.
>> The last time I treated the cables I think only 50% made it in the cable, 
>> hihi.   
>> Any easy way to do this without getting PreLUbe all over the place ?  
>> 
>> Bob
>> K6UJ
>> _______________________________________________
>> 
>> 
>> 
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>                                         
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>