Out of curiosity, I am wondering why you need a cable prep tool. Are
you going into business preping cables?
I use a pocket knife and dikes. The six or so cables a year I have to
prep don't justify gearing up for production quantities.
Phil Snyder wrote:
>Tnx for the replies. Guess I didn't dig quite deep enough on the web
>page for the tool.
>
>Phil
>N9LAH
>
>On 5/25/2012 8:21 PM, Phil Snyder wrote:
>
>
>>Does anyone know if this tool, the DXE-UT-8213 designed to prep RG-8
>>LMR-400 etc. will work on RG-11? I am thinking not as I thought part of
>>the 50/75 ohm characteristic came from the spacing of the shield from
>>the center ( I may also be completely wrong on that point). I could be
>>all wet on this one as well but figured this might be the place to find
>>the right answer, flame or not.
>>
>>Phil
>>
>>N9LAH
>>_______________________________________________
>>
>>
>>
>>_______________________________________________
>>TowerTalk mailing list
>>TowerTalk@contesting.com
>>http://lists.contesting.com/mailman/listinfo/towertalk
>>
>>
>>-----
>>No virus found in this message.
>>Checked by AVG - www.avg.com
>>Version: 2012.0.2176 / Virus Database: 2425/5022 - Release Date: 05/25/12
>>
>>
>>
>>
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk
>
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|