Does anyone know if this tool, the DXE-UT-8213 designed to prep RG-8
LMR-400 etc. will work on RG-11? I am thinking not as I thought part of
the 50/75 ohm characteristic came from the spacing of the shield from
the center ( I may also be completely wrong on that point). I could be
all wet on this one as well but figured this might be the place to find
the right answer, flame or not.
Phil
N9LAH
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|