And un-necessary welding also. Just turn one of the angles over and mount
below the rotor plate . That is what I did in 1991, got idea from a friend in
Oregon, call not mentioned as he is not all that active recently. A company
in Oregon made some of that design. Mine is a dual yagi system rotating a
LJ-105CA (element locations OK) and a slightly modified LJ-155CA (had to
lengthen boom on one end about 18 inches and reposition elements to get
adequate clearance).
Arne N7KA
----- Original Message -----
I agree. Great minds think alike. It appears the Array solutions model
is very similar to the ones I homebrewed. Using the angle irons in a cross
pattern is the way to go. I think it is better to put the torque on all
legs rather than just one.
Bill K4XS/KH7XS
In a message dated 1/30/2012 12:23:09 A.M. Greenwich Standard Time,
jimw7ry@gmail.com writes:
http://www.arraysolutions.com/Products/sidemountusersguide1.htm
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|