I got mine in a couple of days. It has a jumper scheme to set the intensity
in addition to a height setting when soldering the LEDs. I haven't installed
mine yet so I don't know how the actual intensity will be.
73, Larry W6NWS
----- Original Message -----
From: "EZ Rhino" <EZRhino@fastmovers.biz>
To: "Larry" <w6nws@arrl.net>
Cc: "TowerTalk" <towertalk@contesting.com>
Sent: Thursday, December 08, 2011 6:46 PM
Subject: Re: [TowerTalk] Yaesu Rotor Dial Lamp
I have one of these kits. The kit is fine, works fine, marginally bright
enough in my opinion...probably not quite as bright as the stock bulb.
Getting the kit is the problem...order it and wait 6 months, no response,
doesn't answer the phone, ignores emails, etc.
Chris
KF7P
On Dec 8, 2011, at 16:41 , Larry wrote:
IdiomPress makes a small illuminator board for HyGain rotor boxes
which might work. It has 3 LEDs and is intended to sit on top of a
meter with a clear top. It has a rectifier to get the DC voltage for the
LEDs from a 28VAC source in the HyGain units. It was about $11
for the kit I think. I don't know if it would work for the Yaesu control
unit or not. Search for "Rotor-EZ".
73, Larry W6NWS
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|