The motor windings, PINS 4 and 5.
The MANUAL can be found here ;-)
http://yaesu.com/indexVS.cfm?cmd=DisplayProducts&ProdCatID=104&encProdID=E0526A9F285ECCF36F75CC3FEC992990&DivisionID=65&isArchived=0
----- Original Message -----
From: "Williams, Richard (OAG/CPG)" <Richard.Williams@gnb.ca>
To: <towertalk@contesting.com>
Sent: Monday, August 22, 2011 7:37 AM
Subject: [TowerTalk] G-2800SDX Question
> Thanks again to evryone for their suggestions on getting this operational
> again. Operational it is. One final question I have is which two pins on
> the rotor unit itself require the two heavier duty cable leads? Rick VE9HF
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|