The manual calls for six stranded conductors of at least #22 each if shorter
than 131 feet or #18 if longer. It says "If your cable had different sizes
of wire, connect the largest wires to pins 4 and 5, since these carry the
motor current."
I use #18 for my run which is about 180', I think.
Jim N7US
-----Original Message-----
Thanks again to evryone for their suggestions on getting this operational
again. Operational it is. One final question I have is which two pins on the
rotor unit itself require the two heavier duty cable leads? Rick VE9HF
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|