I won't address the splice, be it a male and female "N" end, a regular
splice, etc.
But I would suggest getting a tube of caulk, slitting it, and placing
the splice
inside the tube of caulk. Cheap but effective watertight seal.
"Good Luck, we're all counting on you ..."
73
ed K0KL
On 7/10/2011 9:18 PM, Rich Hallman - N7TR wrote:
> My fence guy was using an auger to drill fence posts and was going to hand
> dig where we thought my hardline was buried to the tower. I was in town when
> he started and he "forgot" what we discussed and sure enough he hit the two
> runs of Andrews ½ inch hardline going to the tower.
>
>
>
> So.....What options do I have for slicing in a jumper? I have extra ½ inch
> hard line available to splice in.
>
>
>
> Thanks...
>
>
>
> Rich N7TR
>
> ex KI3V, N3AMK, WB3JOV
>
> www.n7tr.com<http://www.n7tr.com>
>
> Telnet: dxc.n7tr.com N7TR DXCluster
>
>
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1388 / Virus Database: 1516/3756 - Release Date: 07/10/11
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|