Steve,
Take a look at the Rohn catalog. They have equalizer plates to balance the
load between the upper and lower set of guys. You will need a good
turnbuckle on each guy wire since the guy tension will need adjusting
individually.
Mark N1UK
----- Original Message -----
From: "Steve" <sflory@mindspring.com>
To: <towertalk@contesting.com>
Sent: Sunday, 29 May, 2011 3:09 PM
Subject: [TowerTalk] Guy wire attachment
> what is the best way to attach 3/8 guy wire to a utility anchor? I have
> guy grips , should I use a turn buckle or just the guy grip I am
> installing a 55g at 70 feet guyed twice Thanks Steve
>
> Steve Flory W9KOP
> sflory@mindspring.com
> "I like climbing towers because people look up to me"
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|