I would ASSume (famous last words) that the LM354 and LM472 used the same
hardware? I have the LM472 and can inspect, measure, and take photos if you
wish. I'm pretty sure I have & can share the wiring info on the Leeson
motor, as well as the control box. If you don't find something that
specifically says "LM354", let me know, chances are they're identical except
for 3 vs 4 tower sections.
73
Dan
K0DAN
----- Original Message -----
From: "Doug Dietz" <dcdietz@chartermi.net>
To: <towertalk@contesting.com>
Sent: Sunday, May 15, 2011 9:07 AM
Subject: Re: [TowerTalk] LM354 motor winch
> ,
> I listen I learn....
> My tower is a lm354hd it is also used, someone had a motor on it and it
> has been removed. I have all the drawings and the spec of the motor it is
> a lesson 112431 .500 motor. I should also mention that I have the 40:1
> gear box and the drummer winding the cable is also there. The motor
> pulley is speced at a.625x1.750, and the belts a 4l410 gates 2410, what I
> don't have is the number of the pulley on the gearbox I assume that it is
> in the drawing of the gearbox drum assy I know that it is a 10inch and I
> can get the shaft size off the reducer so I need a number off the 10 inch
> pulley and a wiring diagram. anyone HELP Doug WD8Z dcdietz@chartermi.net
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|