On 10/14/2010 9:27 AM, Mickey Baker wrote:
> Caution - there's a safety issue here.
>
> Used motor oil shouldn't go ANYWHERE except into specific recycling tanks.
> You can find one at most auto parts stores and at the motor pool garages of
> your local government.
>
> The problem is that pollutants from engines (particularly MTBE from fuel)
> are collected in oil. It if makes it out of the engine on to the ground, one
> drop can pollute over 1,000 gallons of ground water so that humans can't
> consume it.
>
I don't know if it's still posted, but at one time "they" used to say
that each year do-it-yourself oil changes put more oil into the
environment than the Exon Valdese oil spill. Of course back in the old
days we put the stuff out in the gravel road, and the county would spray
the stuff on the roads along with brine. Those gravel roads would get
like concrete.
> http://toxics.usgs.gov/highlights/waste_oil.html
>
> Dispose of your used oil properly!
>
> 73,
>
> Mickey N4MB
>
>
> On Wed, Oct 13, 2010 at 9:33 PM, Ro Grrr<rogrrr@hotmail.com> wrote:
>
>> OK, How about pouring used motor oil onto the steel where it comes out of
>> either the concrete or out of the dirt ?
>> I've never seen steel rust/corrode/galvanize if it's coated with oil.
>>
Oil will only produce a temporary protection. It might last for a few
years, but it will eventually disappear.
Part of the problem is the moisture penetrates the concrete surface and
makes it difficult to protect that area just below the top.
Tar on the leg and then a bag of the driveway patch which does seal with
the concrete might work. It'll add weight, but probably not much
strength. OTOH at that point you don't really need much strength.
73
Roger (K8RI)
>> And you can also consider BOILED LINSEED OIL.
>>
>> After all, BOILED LINSEED OIL is THE main ingredient in ZIEBART !
>>
>> RoGrrr
>> KC8HZ
>>
>>
>> Message: 5
>> Date: Wed, 13 Oct 2010 18:13:50 -0400
>> From: "Tony Brock-Fisher"<barockteer@aol.com>
>> Subject: Re: [TowerTalk] Protecting Buried Guy Anchors
>> To: "Towertalk"<towertalk@contesting.com>
>> Message-ID:<778DE90C7B824B53B7E3FDAB5CC0BC8D@Phineas>
>> Content-Type: text/plain; charset="iso-8859-1"
>>
>> >Would it be a good idea to protect against this by applying lime at
>> regular intervals around the guy anchor to increase the
>> soil ph?
>>
>> Absolutely not. Increasing the pH could make the problem worse. The issue
>> is that while there is sufficient galvanizing applied to tower components to
>> protect them in air, this amount of zinc can be uickly used up when buried
>> underground.
>>
>> I would direct you to review an article in the current issue of QST, "Is
>> Your Tower Still Safe", by yours truly. It will explain the problem; how to
>> do an inspection, and what to do to control corrosion fter the zinc is gone.
>>
>> 73,
>>
>> Tony, K1KP
>>
>>
>>
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|