ROHN R-55JBK Bolt Kit for 55G Tower Section
Factory OEM, Original Manufacturer's Bolt Kit in Tube as would be Supplied
with New Tower Section. Each Kit contains:
(6) EA R-210016G BOLT 7/16 X 2-1/2 HCS G5 HDG
(6) EA R-230009 NUT 7/16 HEX FIN TO HDG
http://www.3starinc.com/rohn_bolt_kit_for_joining_55g_tower_section_r-55jbk.html
----- Original Message -----
From: "Stan Stockton" <k5go@cox.net>
To: <TOWERTALK@contesting.com>; <cqtestk4xs@aol.com>
Sent: Monday, 04 October, 2010 9:36 PM
Subject: Re: [TowerTalk] Bolts for Rohn 55 and 65
> Bill,
>
> I think 55G uses two 7/16 x 2 1/2 bolts in each leg. If you have a deal
> on some, I need about 120 nuts and bolts.
>
> I am not sure about the 65G but will also need some of them if you find
> out.
>
> 73...Stan, K5GO
>
>
> ----- Original Message -----
> From: <cqtestk4xs@aol.com>
> To: <TOWERTALK@contesting.com>
> Sent: Monday, October 04, 2010 7:19 PM
> Subject: [TowerTalk] Bolts for Rohn 55 and 65
>
>
>>
>> Anybody know what size bolts are required for Rohn 55 and 65? There
>> is a huge supply of surplus Rohn bolts available and I want to take
>> advantage of it for the new station. My container has not yet arrived
>> from KH6 and I can't measure the stock already have.
>>
>> Thanks!
>>
>> Bill KH7XS/K4XS
>>
>>
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|