Good Day
I wonder if someone can assist me. One of my connections in the shack broke
and I did not take the colors of the pins so in short the problem is that I
do not know which wire is which going to the rotator. Now I cannot connect
the rotator to the rotator without dropping my tower.
Is there a way as with HyGain rotators to measure the wires going to the
rotor of the the Yaesu G-1000DXA to determine which are wires 1 - 6.
I would appreciate any help as I have searched the internet and cannot find
anything in this regard. There is also nothing shown in the manual.
Thank you in advance.
--
Marinus Willemstijn
ZS6MAW
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|