If you'd rather buy them readymade, W9IIX sells them: http://www.w9iix.com/
Jim N7US
-----Original Message-----
I'm going to make some mast steps from 14" long pieces of 2" x 2" x 1/4"
thick 6061-T6
I have been told that a SINGLE dx eng saddle clamp will suffice... and
handles the weight
of a 250 lb man. The dx eng clamp is just 3/8" SS for the U bolt
portion... and the saddle
is 1" wide solid AL. I only weight 150 lbs. Is this safe enough ?
Plan B was to use the
DX eng super mast clamp .. which has solid 2" high saddles on both sides
of the mast.
This is for a 2" mast.
Tnx.... Jim VE7RF
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|