Towertalk
[Top] [All Lists]

[TowerTalk] Mast steps

To: <towertalk@contesting.com>
Subject: [TowerTalk] Mast steps
From: "Jim Thomson" <jim.thom@telus.net>
Date: Fri, 21 May 2010 08:14:13 -0700
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
I'm going to make some mast steps  from  14"  long pieces of 2" x 2"  x 1/4"  
thick  6061-T6
I have been told that  a SINGLE  dx eng saddle clamp will suffice... and 
handles the weight
of a 250 lb man.   The dx eng clamp is just 3/8"  SS  for the U bolt portion... 
and  the saddle
is 1"  wide solid AL.   I only weight 150 lbs.   Is this safe enough ?    Plan 
B was to use the
DX eng  super mast clamp .. which has solid  2" high saddles on both sides of 
the mast.
This is for a 2"  mast. 

Tnx.... Jim  VE7RF 
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>