Hi TTers,
I got that Rohn 45 tilt-over down and home last week. In remarkably good
condition. Only thing I wondering about is the TB3 thrust bearing and how to
lubricate it. It turns freely but has a notable rumbling sound and feel to it.
I notice at the bottom of the inside shaft area where to mast passes through,
is a recessed Allan head fitting/plug. Would this be the place to remove and
squirt in some white grease? And then replace the plug?
Thanks for your guidance,
Kathy
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|