Check with Davis RF and/or Texas Towers for a stripping tool
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of W0MU Mike Fatchett
Sent: Wednesday, April 21, 2010 12:59 PM
To: 'Tower and HF antenna construction topics.'
Subject: Re: [TowerTalk] Stripping LMR-600
I use a stripping tool. They are great!
CC Packet Cluster W0MU-1
W0MU.NET or 67.40.148.194
"A slip of the foot you may soon recover, but a slip of the tongue you may
never get over." Ben Franklin
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Tommy Alderman
Sent: Wednesday, April 21, 2010 4:57 AM
To: 'Tower and HF antenna construction topics.'
Subject: [TowerTalk] Stripping LMR-600
What is the recommended tool for stripping LMR-600 for a type-N connector?
Do most of you use just a sharp blade and careful measurements or do you
recommend the purchase of a stripping tool? If you use a stripping tool, can
you give me a model number and a source please? I'm going to be doing a
limited quantity of less than ten connectors.
Thanks for any information.
Tom - W4BQF
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|