To: | "'Tower and HF antenna construction topics.'" <towertalk@contesting.com> |
---|---|
Subject: | [TowerTalk] Stripping LMR-600 |
From: | "Tommy Alderman" <aldermant@windstream.net> |
Reply-to: | "Tower and HF antenna construction topics." <towertalk@contesting.com> |
Date: | Wed, 21 Apr 2010 06:56:45 -0400 |
List-post: | <towertalk@contesting.com">mailto:towertalk@contesting.com> |
What is the recommended tool for stripping LMR-600 for a type-N connector? Do most of you use just a sharp blade and careful measurements or do you recommend the purchase of a stripping tool? If you use a stripping tool, can you give me a model number and a source please? I'm going to be doing a limited quantity of less than ten connectors. Thanks for any information. Tom - W4BQF _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | [TowerTalk] 7-16 Din, Jim Thomson |
---|---|
Next by Date: | Re: [TowerTalk] 7-16 Din, DF3KV |
Previous by Thread: | [TowerTalk] 7-16 Din, Jim Thomson |
Next by Thread: | Re: [TowerTalk] Stripping LMR-600, Scott Reed |
Indexes: | [Date] [Thread] [Top] [All Lists] |