I should have said " an angle grinder with a metal cutting disk"
Mark N1UK
----- Original Message -----
From: "Mark Robinson" <markrob@mindspring.com>
To: "Tower and HF antenna construction topics." <towertalk@contesting.com>
Sent: Thursday, 01 April, 2010 11:38 PM
Subject: Re: [TowerTalk] Cutting a section of tower
> You could use a hacksaw or maybe a Sawsall. I have used an angle grinder
> with a metal cutting blade before
>
>
> Mark N1UK
>
>
> ----- Original Message -----
> From: "Ed Swiderski, KU4BP" <ku4bp@triad.rr.com>
> To: "Tower Talk" <towertalk@contesting.com>
> Sent: Thursday, 01 April, 2010 5:36 PM
> Subject: [TowerTalk] Cutting a section of tower
>
>
>>
>> Feel that this is a dumb question but can a section of tower be cut with
>> a
>> hacksaw or would I need something stronger? I have a section of 25G that
>> was
>> cut prior to it was given to me and I wish to cut it to make a 5-ft
>> short
>> base section.
>>
>> Thanks,
>> Ed KU4BP
>>
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|