N2TK, Tony wrote:
> Many, many years ago when I needed to tap hundreds of holes at a time and do
> it manually. So I took a block of aluminum - 2" X 1.5" X 1"H. I drilled
> clearance holes for #2, 4, 6, 8, 10, 12 and 1/4". This way it is much easier
> to keep the tap at right angles to the hole being tapped. With Tapfree and
> this block I do not break taps.
>
There is a relatively inexpensive tool that consists of a flared base
and a tap holder that fits into the machined base. Guarantees a
straight/90 degree angle. There is also one with a notch that will
straddle pipe, rod, or tube.
http://www.grizzly.com/products/Tap-Wrench-w-Fixture/H5607
73
Roger (K8RI)
> 73,
> N2TK, Tony
>
> -----Original Message-----
> From: towertalk-bounces@contesting.com
> [mailto:towertalk-bounces@contesting.com] On Behalf Of Charlie Gallo
> Sent: Thursday, March 25, 2010 1:46 PM
> To: Tower and HF antenna construction topics.
> Subject: Re: [TowerTalk] Drill bits
>
>
> On 3/25/2010 TexasRF@aol.com wrote:
>
>
>> After breaking too many 6-32 and 8-32 taps in vhf/uhf cavity amplifier
>> aluminum parts, I discovered a product named "Tap Magic for Aluminum".
>>
>
> Tap Magic for Aluminum is excellent - it's my choice #2 after Alumtap
> original. BTW Tap Magic (without the 'for aluminum') is my choice for most
> other metals
>
> A trivia for you - 6-32 taps are actually one of the easier taps to break.
> The issue is that of the standard thread series (UNC/UNF) they have the
> worst major/minor diameter ratio, which makes them VERY easy to break. It's
> actually harder to break a 4-40 tap
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|