As I remember, when I replaced the k1550 with the k2550, I had to file two
of the mounting plate holes a bit (maybe 1/4" on one side). Other than that
everything fit.
k7puc
----- Original Message -----
From: "luke webber" <luke_webber@hotmail.com>
To: <towertalk@contesting.com>
Sent: Friday, November 13, 2009 8:21 AM
Subject: [TowerTalk] common winch mounting holes?
>
> Hello everyone
>
>
>
> im hoping you can help educate me on the options i might have for
> replacing a Fulton K1550 winch. Are the mounting holes for that winch
> similar to other winches? Just curious to know if i have to modify the
> mounting location.
>
>
>
> I heard that Dutton Lainson has similar winches with similar bolt hole
> locations...are there any others for that size of winch?
>
>
>
> Thanks in advance for the help
>
> _________________________________________________________________
> Hotmail: Trusted email with powerful SPAM protection.
> http://clk.atdmt.com/GBL/go/177141665/direct/01/
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|