BUT, if it's pipe, it may not be seamless
73, Pete N4ZR
New Articles Daily - the Contesting Compendium at http://wiki.contesting.com
The World Contest Station Database, updated daily at www.conteststations.com
The Reverse Beacon Network at http://reversebeacon.net
On 11/2/2009 3:34 PM, Rex Lint wrote:
> Dave,
>
> 6061-T6 has Tensile strength of 42K PSI and yeild at 35K PSI - See
> wikipedia.
> Stainless varies from about 75K to 190K PSI Tensile, depending on the
> allooy. See http://www.onlinemetals.com/stainlessguide.cfm
>
> -Rex-
>
> K1HI
> Rex Lint
> Merrimack, NH
>
> -----Original Message-----
> From: towertalk-bounces@contesting.com
> [mailto:towertalk-bounces@contesting.com] On Behalf Of David Jordan
> Sent: Monday, November 02, 2009 2:10 PM
> To: TowerTalk@contesting.com
> Subject: [TowerTalk] Stainless Steel Mast
>
> Hi Folks,
>
>
>
> I found a nice length of stainless steel pipe 2" OD (.250" wall) by 10ft
> that I thought might make a nice mast stub. How would this tubing's
> strength compare to 6061 aluminum of similar dimensions?
>
>
>
> Thanks,
>
> Dave
>
> Wa3gin
>
>
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|