Well, I got to thinking that teh Molwaukee Hoel Hog at 300 RPM would be too
fast for the
tower tilting application and thinking about wjat an appropriate RPM would
be
I come up with 90 to 120 RPM - So the questions is
What 1/2 inch chuck drill ( that uses a Chuck Key and not those stupid hand
tightening chucks )
that was variable speed and reversable) would be able to develop
significant torque and not
overheat at that RPM.
I have a call into Makita Engineering Department but after talking to one of
the tech ZSipport people
have my doubts that I will even get a call back. The tech guy I talked to
didn't even have a clue
what I was talking about when I mentioned torque curves for different RPM
and all I get from makita Engineering Dept is voice mail....
I don't see anything that Miwaukee offers in theor line of drills.
Anyone on this ref;lector been down this road before or is back to teh tower
with "armstrong" methode and a Tag tem.
I plan to use a Fukton KW3000 worm gear type winch that ha s gear ratio of
51.1 to one
which is way too slow to crank by hand
http://www.fultonperformance.com/Couplers/pdfs/Ceq-Couplers-pgs19-25-08.pdf
73, Dennis N6KI
On Tue, Jul 21, 2009 at 9:22 AM, Richard (Rick) Karlquist <
richard@karlquist.com> wrote:
> Roger (K8RI) wrote:
>
> Most of the 1/2" and 5/8" variable speed drills will turn less than 60
>> RPM, but you need one that has a motor up to the job. I have 4. 2 Lithium
>> battery powered and 2 AC powered. I have burned up the motors in three. One
>> was actually blowing flames when I was drilling 3/4" holes in 1/2" thick, 4
>> or 5" I-beams.
>>
>> 73
>>
>> Roger (K8RI)
>>
>
> My Milwaukee is the plug in type (yes they still make them). I have
> power at the tower for the raising winch so battery operation is
> not required. It overheats after a minute or so when the load is
> large. I don't see any solution to that in a drill you can hold
> in your hand; its limited by physics. When the drill is cooling,
> I crank by hand. The drill and I are a tag team :-). The winch
> needs to rest too so it doesn't overheat.
>
> Rick N6RK
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|