Hi,
I used a rather large, 4" diameter, 12" long solenoid with two parallell
windings as a common mode choke for the ladder line to my windom antenna.
Worked OK for my purpose. Kept the RF out of the shack. Used #14 wire with a
little space between the wires. Have no idea how it affected the "SWR" in/on
the line, but who cares. It is a ladder line after all.
I don't see a practical solution to put a ladder line through a toroid core
unless it is incredible large. It should be possible though even if it will be
heavy. :-)
73 de N2JFS Hans
-----Original Message-----
From: jimlux <jimlux@earthlink.net>
To: Jim Brown <jim@audiosystemsgroup.com>
Cc: chas <chasm@texas.net>; towertalk <towertalk@contesting.com>
Sent: Tue, 5 May 2009 10:27 pm
Subject: Re: [TowerTalk] Ladderline - what are the facts??/
Jim Brown wrote:
> On Tue, 21 Apr 2009 00:14:50 -0500, chas wrote:
>
>> WHERE are the facts about ladderline??
>
> Ladderline does not radiate differential mode current (the power it
> carries from the transmitter to the antenna). Ladderline DOES
> radiate COMMON MODE current. So does coax.
>
> Common mode current is the result of imperfect balance at either end
> of the feedline. Nearly all practical ham antennas are unbalanced by
> their surroundings. Common mode current causes radiation, and
> antenna imbalance causes common mode receive current.
>
> An important difference between coax and ladder line is that coax
> can be CHOKED to kill common mode current, but ladder line cannot.
Just wondering out loud here.. If I put a twisted pair (unshielded) or
ladder line through the center of a ferrite toroid, would it not choke
the common mode currents? I can see this being somewhat impractical for
ladder line, although with some sort of appropriate spacers to make sure
it's perfectly centered, and the toroid would have to be big enough that
it didn't intercept much of the differential mode field.
(that is, with 1" wide ladder line, you'd probably need a ferrite with a
6-8" hole )
(hmm, one could design a common mode choke for a balanced transmission
line. they're pretty common for switch mode power supply inputs, so the
challenge is designing one for HF.)
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|