Towertalk
[Top] [All Lists]

Re: [TowerTalk] Cage Vertical ideas wanted.

To: "Jim Hargrave" <w5ifp@gvtc.com>, "Tower" <towertalk@contesting.com>
Subject: Re: [TowerTalk] Cage Vertical ideas wanted.
From: "W5CPT" <w5cpt@bellsouth.net>
Date: Sun, 7 Dec 2008 16:29:50 -0600
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Thanks Jim,
That is exactly the kind of solution for which I was looking!

Clint - W5CPT

  ----- Original Message ----- 
  From: Jim Hargrave 
  To: Tower 
  Sent: Sunday, December 07, 2008 3:51 PM
  Subject: Re: [TowerTalk] Cage Vertical ideas wanted.


  Clint,

  You can use the thin drain pipe and drill the attaching holes through the
  side of each ring. Then you can attach the antenna wires to the ring by
  using small nylon cable ties. Pass them thru the hole and out one end
  clamping each wire in the same manner. This will keep the spacing
  consistent. if you drill the holes near one end of the ring, the ties will
  be short and hold the wire tight enough to keep the ring from sliding down
  the antenna. You can even wrap the cable around the ties before closing it
  to provide a little more friction to better hold it in place.

     * 73's Jim W5IFP *



     >-----Original Message-----
     >From: towertalk-bounces@contesting.com
     >[mailto:towertalk-bounces@contesting.com]On Behalf Of W5CPT
     >Sent: Sunday, December 07, 2008 7:14 PM
     >To: towertalk@contesting.com
     >Subject: [TowerTalk] Cage Vertical ideas wanted.
     >
     >
     >I have decided to build a Cage Vertical.  I can get about 80 to
     >100 feet straight up by suspending it from a catenary strung
     >between two of my taller trees.
     >
     >
     >
     >Two points:
     >
     >
     >
     >1 The wire I intend to use is Fishing Line. I tried to post the
     >link but it ends up being 3 lines long, so go to cabelas.com
     >and search for  item number wt-12-1511.  I built a dipole out
     >of this stuff and it solders and crimps well and appears to
     >last for a long time.
     >
     >
     >
     >2. I need ideas on what to use for spreaders.  The 45 lb. test
     >line is .037" which is too big to use a thin slice of 6" PVC
     >drain pipe as I cannot drill holes edgewise into the pieces
     >large enough to accept the wire and small enough to not
     >compromise the strength of the slice of PVC.  I am considering
     >5 or 6 wires in a 5 to 6" diameter and need some suggestions on
     >what to use.
     >
     >
     >
     >Suggestions about the spreaders and other comments are always welcome.
     >
     >
     >
     >Clint - W5CPT
     >
     >
     >_______________________________________________
     >
     >
     >
     >_______________________________________________
     >TowerTalk mailing list
     >TowerTalk@contesting.com
     >http://lists.contesting.com/mailman/listinfo/towertalk
     >No virus found in this incoming message.
     >Checked by AVG - http://www.avg.com
     >Version: 8.0.176 / Virus Database: 270.9.15/1834 - Release
     >Date: 12/6/2008 4:55 PM
     >

  _______________________________________________



  _______________________________________________
  TowerTalk mailing list
  TowerTalk@contesting.com
  http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>