Small split bolts for copper wire are another good solderless alternative,
particularly for high power. Available at Home Depot, etc. They also make
a mechanically strong connection.
73, Pete N4ZRAt 11:42 AM 12/7/2008, Wayne Kline wrote:
>
> For low band 160. a quick coax to wire is either little copper bugs or
> the tried a true " ideal plastic wire nut " BTDT
>
> Wayne W3EA
>
> > From: WA6RKN@ARRL.net> To: towertalk@contesting.com> Date: Sun, 7 Dec
> 2008 08:07:48 -0800> Subject: Re: [TowerTalk] wx proof connector> > Pair
> of Powerpoles?> > ----- Original Message ----- > From: <KI9A@aol.com>>
> Subject: [TowerTalk] wx proof connector> > > > Gang-> > I'm looking for
> ideas of a quick disconnect, so I can do this when I get > > on> > 160
> for contests. Outside of soldering, then de-soldering, I am drawing a> >
> blank on what would be a good connector to use.> >
> _______________________________________________> > > >
> _______________________________________________> TowerTalk mailing list>
> TowerTalk@contesting.com>
> http://lists.contesting.com/mailman/listinfo/towertalk
>_________________________________________________________________
>Suspicious message? There's an alert for that.
>http://windowslive.com/Explore/hotmail?ocid=TXT_TAGLM_WL_hotmail_acq_broad2_122008
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|