Put banana plugs on the feed line and make up a connector board
or switch box or the like, so that you can easily switch it from
A = doublet, and B = T-160. Mount this this in a small
project box or on a board, so you can either throw a switch
between the A and B settings, or unplug the banana plugs
form the A format, into the B format and you are quickly
changed over. Designing a simple A/B switch box would
eliminate the banana plugs, but be more involved. Otherwise
the banana plugs are easy to unplug from the A wiring and
plug into the B and vice versa on the fly.
Just MY take. ======== Richards - K8JHR ========
===========================================
KI9A@aol.com wrote:
> I'm looking for ideas of a quick disconnect, so I can do this when I get on
> 160 for contests. Outside of soldering, then de-soldering, I am drawing a
> blank on what would be a good connector to use.
>
=============================================
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|