Towertalk
[Top] [All Lists]

Re: [TowerTalk] "Sluggo" Ground Rod driver

To: Tower Talk <towertalk@contesting.com>
Subject: Re: [TowerTalk] "Sluggo" Ground Rod driver
From: Robert Morris <robrk@nidhog.net>
Date: Thu, 16 Oct 2008 18:02:57 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Find the largest sledge hammer you can pick up. Knock out the wooden 
handle, weld in place  3 or 4 feet of 1' pipe. On ground rod day, slide 
pipe over rod, stand vertical,in the 1 foot hole you dug, push up on 
pipe, then let go.
Repeat until rod is 2 feet tall. Tap in with hammer end. No ladders, 
busted fingers or toes.

Bob Nielsen wrote:
> I bought a 6 in. length of  1 in. pipe and a cap at Home Depot which  
> has worked fine for me at a cost of less than $5.00.  I figure that  
> after a dozen or so ground rods I might have to replace the cap  
> because of the sledge hammer abuse, but it does the job just fine,  
> without any mushrooming of the rod.
> 
> I got the ground rod over 4 feet into the ground of Bainbridge  
> Island, WA without even using the sledge (I sure couldn't have done  
> that when I lived in caliche-infested Tucson, Arizona).
> 
> Bob, N7XY
> 
> On Oct 16, 2008, at 1:50 PM, Tom Anderson wrote:
> 
>> Fellow Tower Talkians:
>>
>> I just checked their web site and the MSRP is $119.95 which does  
>> make it a bit pricey.
>>
>> Tom, WW5L
> 
> 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
> 

-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>