Towertalk
[Top] [All Lists]

Re: [TowerTalk] M2 2800 question

To: ab7r@cablespeed.com, towertalk@contesting.com, k9kl@centurytel.net, K7LXC@aol.com
Subject: Re: [TowerTalk] M2 2800 question
From: Greg - AB7R <ab7r@cablespeed.com>
Reply-to: ab7r@cablespeed.com
Date: Mon, 25 Aug 2008 13:56:42 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
The guy doing the tightening didn't use anything other than a normal ratchet 
when tightening.  
It is very possible it could have been a defective U-bolt.  The others 
tightened down with no 
problem.

When I install my clamp, I'll use the washers as suggested...thanks.

Can I get the modified bolts?  QRZ address is good.  Thanks. :)

-------------------------
73,
Greg - AB7R
Whidbey Island WA
NA-065


On Mon Aug 25 14:09 , K7LXC@aol.com sent:

> 
>In a message dated 8/25/2008 8:13:45 A.M. Pacific Daylight Time,  
>ab7r@cablespeed.com writes:
>
>>  1.  Be carefull when tightening the nuts on the  U-bolts.  A friend of 
>mine was 
>
>helping with an installation and  it did not take much to snap one off.
>
>
>    What's not much? I've been installing towers for  over 10 years (along 
>with several of the Orion clamps) and have yet to  snap off any bolt head.
>
>>  2.    But the reason  I had not yet installed the 
>
>replacement clamp was for two  reasons.  1.  the bottom was not flat.  On a 
>flat  
>
>surface it rocks back and forth.  When installed and things are  tightened 
>down this 
>
>may or may not be a problem.  But it just  does not seem right.  
> 
>    The clamps are heavily welded and hot-dipped  galvanized so they started 
>off flat but the two hot processes have apparently  had some effect. Is it a 
>problem? Not really. If you're really worried about  it, put a washer between 
>the turntable and clamp for each bolt. Voila - flat.  
>
>>  The other thing is 
>
>that the holes for the bottom bolts  are very close to where other parts are 
>
>welded.  You actually  have to use a cutting wheel and cut the side of the 
>nut so 
>
>that it  fits correctly.
> 
>
>The clamps are now supplied with  2 bolts with a flat side. 
>
> 
>Cheers,
>Steve     K7LXC
>TOWER TECH
>and
>Champion Radio Products
>Cell: 206-890-4188
>
> 
>
>
>
>**************It's only a deal if it's where you want to go. Find your travel 
>deal here.      
>(http://information.travel.aol.com/deals\?ncid=aoltrv00050000000047)
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>