During the install the main board [ie: all electronics] are removed
from the control box
They want to make sure any mods already performed are also removed..
At 05:03 PM 7/28/2008, Gary Stone wrote:
>"Before going any further, remove any circuits added to the rotator control
>box after its manufacture, especially brake delay circuits, and insure that
>the rotator control box is restored to factory design and specifications."
Jack Hartley
K4WSB / VP2MSB
ARRL - QCWA - OOTC
DXCC Honor Roll
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|