Home Depot sells galvanized ground clamps in various sizes up to 2
inches that will handle wire much thicker than #4. The best approach
would be to just use two clamps on each leg, but if you're cheap you
could slightly flatten each wire with a hammer and fit both wires in one
clamp.
Dave AB7E
Roy & Peggy Bonvillian wrote:
> I have just set my base for my 55G and have my UFER ground wires that need
> to be connected to the legs of the tower. I have 3 #4 gauge wire coming out
> of the cement near each leg. My question is where do I fine the proper
> clamps to connect the bare copper wire to the 3 legs and also have a place
> to tie in the wire leaving each leg going out to the ground rods?
> ROY
> WD5DBV
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|