All,
Accidentally pulled out 3 wires from the control box on my Yaesu
G-1000DXA rotator while rearranging the shack. The wires were connected
to pins 4, 5 and 6. I reconnected the wires to what I thought was the
order they came apart, but the rotator does not spin.
I tried different combinations with the three detached wires and I'm now
wondering if I could have shorted something. It was working fine before
this happend and a continuity test says the connector is fine.
If there is a problem, would it be at the rotator or at the control box?
Tony
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|