To: | TTalk <towertalk@contesting.com> |
---|---|
Subject: | [TowerTalk] UST MDX-589 Electrical Question |
From: | Les Kalmus <w2lk@earthlink.net> |
Reply-to: | w2lk@earthlink.net |
Date: | Mon, 18 Feb 2008 15:46:20 -0500 |
List-post: | <towertalk@contesting.com">mailto:towertalk@contesting.com> |
I have an older US Tower, model MDX-589. The motor is wired for 120V. The motor label clearly shows it can be set for 240V. I have had 240V brought to the tower site. Can someone tell me if the raise/lower toggle switch needs rewiring for 240V? If so what needs to be done? I know people with MDX-589 towers which run at 240V but I don't know if the switching is the same. Les W2LK _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TowerTalk] AMP Fusion tape for sealing/waterproofing. DAVIS RF Co. input, Dino Darling |
---|---|
Next by Date: | [TowerTalk] Yaesu G-2800DXA in Rohn 25?, ac9s |
Previous by Thread: | Re: [TowerTalk] AMP Fusion tape for sealing/waterproofing. DAVIS RF Co. input, TexasRF |
Next by Thread: | Re: [TowerTalk] UST MDX-589 Electrical Question, Richard (Rick) Karlquist |
Indexes: | [Date] [Thread] [Top] [All Lists] |