#1 is absolutely correct, nay even critical. #2 has not been my experience
in 11 years with three different Yaesu rotators, all pinned.
73, Pete N4ZR
At 08:46 PM 12/26/2007, Blake Meinecke wrote:
>#1 Tighten the mast clamp EXACTLY LIKE the instructions say
>#2 Resist the urge to pin the mast to it!!!!
>
>Ignore #1 and you'll break the clamp.
>Ignore #2 and you'll end up with an aluminum housing full of thousands of
>little bits and pieces.
>
>
>73,
>Blake N4GI
>
> > -----Original Message-----
> > From: towertalk-bounces@contesting.com [mailto:towertalk-
> > bounces@contesting.com] On Behalf Of RICHARD SOLOMON
> > Sent: Wednesday, December 26, 2007 22:54
> > To: k1ttt@arrl.net; towertalk@contesting.com
> > Subject: Re: [TowerTalk] Yaesu G800s Rotator
> >
> > I am considering the YAESU G-2800DXA for my LM-470.
> > Am I making a mistake ??
> >
> > 73, Dick, W1KSZ/7
> >
>
>
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|